|
STI recently tested the capabilities of our printers compared to the competition. The results are amazing and will clearly show you that Zcorp 3D printers are the only choice for 3D printing. Test VRML Model: A vrml (.wrl) file | 27 cubic inch housing | approx. 8 x 10 x 8 inches |
|
|
|
|
|
Setup Time: 5 minutes |
Setup Time: 5 minutes |
|
Build Time: 9 hours |
Build Time: 77 hours |
|
Post Processing Time: 1 hour |
Post Processing Time: 1 hour |
Z
450 Printer
Zcorp
Competition| Material Cost: $54.00 | Material Cost: $155.25 |
| Waste Cost: $0 | Waste Cost: $45.00 (Non-reusable) |
| Automated Removal: Yes | Automated Removal: No |
| Color: Yes, 24 bit color | Color: No, monochrome only |
| Layer Thickness: .003 in. | Layer Thickness: .010 in. |
| Resolution: 450 dpi | Resolution: 180 dpi |
| Speed: 1.00 - 2.00 vertical inches per hour | Speed: 0.13 vertical inches per hour |
| Support Structures: No | Support Structures: Yes |
| Consumables:
HP Print Head, Binder, Powder, Cyanoacrylic, Distilled Water |
Consumables:
Glazing Putty, Adhesion Promoter, Flexible Primer, Wax and Grease Remover, Sandpaper, Needle file set, X-Acto Knife, Squeegee, Tape, Gap Filling Glue, Weld Glue, Filament Cartridge, Support material Cartridge, Soluable Concentrate, Foam Foundations |
| Consumable Costs: Amortized $2.00 per cu. in | Consumable Costs: Amortized $5.75 per cu. in. |
Solution: The Zcorp System is so much faster and so much less expensive to use!
Home | About Us | Services | Contact
© 2006 Solid Technologies, Inc. All Rights Reserved. 650 Sentry Parkway Blue Bell, PA 19422